Succulent and Beautiful BBQ Beer-Can Chicken

Original recipe adapted and modified from Cook's Illustrated
Photos from Cook's Illustrated

We have done a lot of beer-can chickens in our day, but when I saw the techniques that the Cook's Illustrated Test Kitchen used, I was converted. Using these techniques have substantially improved the appearance and flavor of our chickens. Read all the way through the recipe and the additional info before you start. You are gonna be really glad you tried this!

TIPS:

• Bank the coals in the grill on either side of a disposable aluminum pan. The coals will cook the chicken evenly and the pan will catch dripping fat from the chicken.
• Open the top of the can wide open with a church key to allow the greatest amount of steam to escape. The normal hole is far too small.
• Lance the chicken’s skin with a skewer to make holes from which rendering fat can escape.
• Rub the chicken liberally with a spice rub on top of and underneath the skin.
• Coat the chicken with a sweet-tart glaze towards the end of cooking to improve the chicken’s flavor and color. If applied too early, the glaze will burn.
  

Makes 2 chickens, serving 4 to 6

Look for chickens that weigh between 3 and 3 1/2 pounds; if they are significantly larger, you may have trouble fitting the lid on the grill.

Spice Rub

2 tablespoons packed light brown sugar

4 tablespoons Creole seasoning

2 teaspoons freshly ground black pepper

Glaze

2 tablespoons packed light brown sugar

2 tablespoons ketchup

2 tablespoons white vinegar

2 tablespoons beer

1 teaspoon hot sauce

Beer and Chicken

2 (12-ounce) cans beer

4 crumbled bay leaves

2 whole chicken (3 to 3 1/2 pounds each), patted dry

4 cups mesquite wood chips

1. For the spice rub: Mix brown sugar, Creole seasoning, and black pepper in bowl.

2. For the glaze: Stir brown sugar, ketchup, vinegar, beer, and hot sauce together in medium bowl. Add 1 tablespoon spice rub.

3. For the rest: Measure out 1 cup beer from each can; take 2 tablespoons from measured beer and add to ketchup glaze. Prepare beer cans as shown in photo 1, and add 2 crumbled bay leaves to each can.

4. Prepare chickens as shown in photos 2 through 4.

5. Soak wood chips in bowl of water to cover for 15 minutes. Light large chimney starter filled with charcoal briquettes (about 90 coals) and burn until charcoal is covered with fine gray ash. Place 13 by 9-inch disposable aluminum roasting pan in center of grill. Pour half of coals into pile on each side of grill, leaving pan in center. Scatter wood chips evenly over coals, set cooking grate in place, cover, and let grill heat up 5 minutes.

6. Place chickens (on cans) on center of grate, using drumsticks to stabilize them. Cover and grill until skin is well browned and very crisp, 40 to 60 minutes. Brush with ketchup glaze and grill, covered, until thigh meat registers 170 degrees on instant-read thermometer, about 20 minutes longer. Wearing oven mitts or using wad of paper towels, transfer chickens (still on cans) from grill to cutting board and let rest for 10 minutes. Hold base of can with oven mitt or wad of paper towels, insert tongs into neck cavity of chicken, and pull chicken off can. Carve and serve.

Flavor That's More Than Skin Deep

From its crisp, spiced skin to moist meat, beer-can chicken is flavored through and through. Here's how to get the ultimate beer-can chicken experience from your grill.

1. Use a church key can opener to punch holes in the top of the can; this will allow the maximum amount of steam to escape.

2. Loosen the skin on the breasts and thighs of the chicken by sliding your fingers between the skin and the meat.

3. Massage the spice mixture on the skin, under the skin, and inside the cavity.

4. Using a skewer, poke the skin all over to render as much fat as possible.